Quick start: from unboxing to your first pull

This is the fast version of your first session. Follow the links for full detail on any step.

1. First-time setup

Unscrew the base cap, slide the battery out, peel off the insulating sheet, reinstall the battery, and tighten the cap. One-time only.

2. Charge the battery

Plug the USB-C cable into the base of VOLTA. Charge to 100% before your first session. Full charge takes about 1 hour.

3. Load the bowl

Place a bottom screen into the Ceramic Bowl (Chamber). Add ~10g of molasses, loosened evenly. Cover with an upper screen. Wipe the bowl rim clean.

4. Assemble and attach to your hookah

Drop the bowl into the heating chamber. Tighten the top cap. Insert the silicone grommet (16mm or 18mm) into the base cap. Attach VOLTA to your hookah's bowl adapter.

5. Power on

Press the Power (O) button once, then quickly press it again and hold until the OLED screen turns on.

6. Set your session

• 1 click O to set session duration
• 1 click < to set Cap (top) temperature
• 1 click > to set Side temperature

The screen auto-saves when you stop adjusting.

7. Start preheating

Double-tap O to begin the 8-minute preheat. The screen shows a blue countdown and the real-time temperature.

8. Enjoy your session

When preheat ends, the screen reads "Enjoy your session." To extend the session, double-tap O during the session. Each tap adds 10 minutes. Maximum session length is 150 minutes.

Caution

The top cap and bowl area get hot during a session. Use the tweezers to remove the bowl, and only after the device has cooled.